I agree with you there.However its a tossup who the certified idiot is.If the United States can only find a George Bush and an Al Gore to run for president we need to find different people to pick candidates.This corruption on both sides is killing us.Since I only put out hate according to Rodney or whoever,both sides deserve it for that matter.I dont see the advantage of Bush over Gore.They both are worthless.Bush may be the worst since he is the mastermind Cheneys puppet.That right there has to have people all over the world rolling in the floor laughing at us.Left or right,both look stupid to me.Especially right,as in John Ashcroft,theres an idiot for you,then theres that bunch of preachers.The agenda of the left is maybe a little worse,but its kind of like a tossup.You know the far left is wrong,and the far right is insane.Where most of us live at,in the middle somewhere is sick of both sides.Thats a volatile situation.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
