JimH SW PA. The first thing I am wondering about (maybe not fully understanding)is you say that you have a 100 amp panel "protected" by two 50A breakers. This is being fed w/ #10 wire?? What size breaker is the #10 feeders hooked to at the main Panel?? I hope not a 50AMP. #10 wire is good for 30 amps. That is the first problem. Now. You are backfeeding a 50A welder recepacle through a sub panel to the main panel?(this is how I am understanding it). The biggest problem I see is the following scenario....
Electric goes out. You go out the garage, hook up your apparatus to the welder outlet. Start your generator. Did you first throw your main breaker off???? Lets hope so. If you dont..... You make injure a lineman who is trying to get your electric back on, or, if the electric comes back on, kiss your generator good bye. It most likely is going to be orbiting the earth.(blow up) I am not trying to say what you have wont work, but, wouldnt it be easier to throw a switch, start and plug in your generator and be done?? What if you arnt home, wich would be easier on your wife???
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
