Posted by 1 Dollar on December 03, 2008 at 18:32:00 from (65.29.88.166):
So I went around and got anout 130lbs. of wheel balancing weights from some local tires shops. (the big stores don't give it away, try the little guys). I got it all for free, so the was awesome! I was also given about 10lbs. of pure lead sheets from old x-ray films by a doctor, so I'm up to 140lbs before melting down.
Pretty simple from there, melt down the lead. I did end up casting it though, since I has so much. I used a metal spackling mix pan as the mold.
Here is my set-up, I just used a wood fire.
I just put those handles on the pot to put myself further away from the hot stuff. I wore welding gloves. Holding 52lbs. of molten lead at that distance from my body was heavy enough!
I didn't get any action shots, but here is what the "bricks" look like: And here is the mold I used. You can buy them at any hardware store. I did spray it with cooking spray, and the lead popped right out.
So there are the surprisingly good results. I ended up with 120lbs. of cast weight, so I lost about 20lbs. in steel clips off the weights.
Those weights will go on the front of this snowplow, right on top of that rusty weight that is already up there.
Hope somebody learns something here. I'm just trying to give back a teeny bit :-)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
