Posted by RayP(MI) on December 03, 2008 at 15:11:50 from (207.241.137.116):
A ham operator friend contacted the ARRL (Amateur Radio Relay League) regarding the new digital TV. His question had to do with interference to the new broadcasting mode by ham radio equipment. The following is their response. First time I have been able to get a handle on frequencies. Apparently they are not all being moved into the UHF spectrum. This means you will still be using conventional broad band antennas like we are now using. Don't know why the media has been so closed mouthed about this. Maybe they're too dumb to know the information, and too lazy to go looking for it. Or don't think it is important!
From the ARRL:
"The new digital TV channels are still 6 MHz wide. Furthermore, the frequency allocations from Channel 2 to 51 will also remain the same. The frequency spectrum from Channel 52 and up will be reallocated for other uses.
With DTV, it tends to be an all or nothing scenario. This means that interference will not be noticeable up to a certain threshold. Beyond the threshold, the interference will prevent reception of the entire signal.
With regard to testing, most cases of interference to television from the Amateur Radio Service are primarily caused by fundamental overload. In this situation, the TV receiver improperly responds to a strong signal outside its intended band pass. The interference from an HF station can be cured in most cases using common mode chokes and a brute force ac line filter. This should be equally true with DTV. "
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.