Posted by John B. on November 26, 2008 at 15:32:39 from (38.114.64.159):
In Reply to: Re: Wind Chill posted by kyplowboy on November 24, 2008 at 17:48:13:
Dave, You are correct! One thing to consider is you are trying to put heat into the tractor by plugging in the block heater. I was basically talking about one that is not plugged in. Your theory is correct but compare it to using a small torch to heat up a big hunk of iron it will take for ever and even longer if something is trying to cool it down by pulling the heat way. But a bigger torch would heat it up to make up the difference. The metal once cooled will never be any colder than the ambient temperature. Take two thermomters or tractors and let them set out side but cover one up and in the morning before the sun comes up see which one is colder. I've done it and they're the same temperature.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
