Posted by New Handle Again on November 08, 2008 at 17:53:03 from (208.81.157.90):
In Reply to: OT: Fireplaces posted by Casey in Ky on November 08, 2008 at 15:14:00:
I would be absolutely certain that the chimneys are clear before I ever struck a match. They could be creasoted up or have bird nests in them. A house filled with smoke is no fun and may cause a big repair bill. And especially with a repo, you don't know how well things were taken care of.
My family's experience with using a fireplace for heat was not very good until we got tight fitting glass doors to control the flow of air out of the house. With a nice fire going, it felt great in that room, but you could feel the draft coming in around the back door, and the other rooms were cold. And when the fire burned down, you still had to leave the damper open to avoid the CO still coming from the coals. A lot of warmed air went up the chimney. When we got the glass doors installed, the heating effectiveness of the fireplace went up a whole bunch.
However I think you would find that the efficiency of most any wood stove is many times as good as a fireplace.
The other part of the equation is what it costs to get your wood. If you have trees on your property and it only costs the expense of cutting and splitting the wood, it is one thing. If you are paying $250 a cord to have someone else cut the wood and dump it in your driveway, it is something very different. Wood heating is also fairly labor intensive, as you have to keep feeding a fire and carrying in wood, and wood heating is very messy, both from junk on the wood and from having to deal with the ashes.
Wood heat works when the power doesn't, so it is great for emergency heating. But if you have a heat pump system, I am guessing that using a fireplace for auxiliary heating will end up costing you more than if you just left the dampers closed and ran the heat pump. Do you really want to mess with it? Good luck!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
