Posted by ChadS on November 03, 2008 at 05:47:26 from (4.224.78.252):
In Reply to: Re: auger uprighted posted by Jim H SW-PA on November 02, 2008 at 21:07:25:
Id think about pulling the flighting out and making sure there are no bent spots in the screw. from the impact of the fall over. Seen many augers lay down, and work, but had some bent tips on the screw. made the whole thing shake when it was loaded with grain. If it sits out in the sun on a warm day, check for bowing, then readjust a tad to help get it straighter. Inspect the bolts on the flanges where the tube joins, have seen bolts half broke and barely holding the tubes together. Looks like a 60'+
I got a rebuilt kewanne 8X60 ready to go if any body needs one! Oil bath drive, pto driven, also have electric mounts to convert. CHad
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
