The 6011 rod is probably the most useful rod for an AC welder. It has deep penetration, will work well on a dirty and rusty surface, and has a quick "freeze" making it useful for vertical welding. It will give a good weld with relatively little practice. If you use multiple passes, you should chip the slag coating between passes, but it has some tolerance if you don't get the previous layer totally clean.
I have no idea what diameters of rod you may have. But IIRC, the 1/8" diameter can be run at about 100 amps. The size is determined by measuring the diameter of the steel rod, not the OD of the whiteish coating.
To get the arc started, strike the rod on the steel like you might strike a wood match, only a bit more vigorously. If the rods are old, put them in an oven at a lower temp like 200 to 250 F for a few hours to drive out moisture. The 6011 is pretty tolerant of moisture, but they are easiest to use when totally dry.
I built a lot of stuff with my Lincoln 225 AC machine, mostly using 6011 rods. If you are trying to weld thin metal like 14 gauge or thinner, you will need a different rod. The 6011 has too deep penetration for thin stock, and blows holes in it. It is easy to use with 1/8" thick stock and heavier.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
