Posted by old on October 25, 2008 at 15:15:59 from (4.245.2.50):
Well it took me all day but I have the tranny pulled back and the clutch laying on the back of my truck. Pressure plate was still in good shape as was the disk, I'll replace them any how just so I have new in there. Throw out bearing did rattle some but not all that bad. What I did find was odd. The nose cone of the tranny is broken so the throw out bearing would jump up and down and hit the spinning shaft of the tranny and that was probably all the noise I was hearing. I think the reaso it worked oddly was the pieces of the broken off nose cone where in there and probably getting into places that made it work strangely. Also found I have a bad u-joint on the front drive shaft so I'm going to replace them all on the front shaft. Haven't looked at the pilot bearing yet but I'll almost bet its bad
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
