Posted by buickanddeere on October 24, 2008 at 05:19:07 from (66.135.114.231):
In Reply to: Re: 3 phase wiring posted by Walt davies on October 23, 2008 at 08:43:10:
The ground wire is not to carry running current, That is what the insulated white is for. The bare ground wire is used to hold the chassis, not the current path down to ground potential. The ground is also supposed to keep the neutral from floating above earth potential. If ground and neutal was the same. Why does the electrical code call for three live lines, an insulated neutral and a bare ground, five wires? A 120/208 grounded Y system is very flexable and economical system to install and operate. 120V single phase loads, "240V" single phase and three phase motors. Even 347/600 three phase with with a delta/Y transformer. No wild legs and odd taps as some of those grounded deltas have.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
