|
Tractor Talk Discussion Board |
Re: Lead Paint and Old Tractors
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Mark on March 16, 2000 at 09:58:09 from (207.127.228.14):
In Reply to: Lead Paint and Old Tractors posted by Mike on March 14, 2000 at 14:08:29:
Mike, I have the same tractor and plan on doing the same this summer, mine has the original paint plus at least two additional brush on coats added. I did a 8n a while back simply sandblasting and making a beach out of the back yard, you need at least a 5 hp compressor to keep up with a relatively small sand blaster. If you do blast I would block up the tractor on blocks, and lay down three to four blue poly tarps, to catch the sand, blast for an hour or two pull up the tarps and dump into a barrel to dispose of in a safe manner. You can set up a back drop with a couple of pieces of plywood. You definately need a respirator, heavy gloves and a full face mask works well, don't depend on eyeglasses as you will sand pit them forever. If you do blast use the heavy black oxide for the cast iron, and the lighter silica sand for the sheet metal at a lower pressure, do not bother with beach sand as it is not screened and tends to clog up. This time around I plan on attacking the tractor cast iron first with one of the citric based paint removers,and a high pressure washer, along with a stiff wire cup brush on a 4.5" angle grinder. I will probably blast the hood and fenders. I worked as a commercial sand blaster for a building restoration service and will tell you it is not all that fun. The effort is worth it, just plan on this as a good part time job for two weeks or so. This time before painting I plan on trying the pressure washer with the prep solution for painting aluminum siding to clean up the citric acid paint remover, don't know if it is needed but that only another hours work. Good Luck
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|