Posted by rrlund on October 15, 2008 at 10:00:36 from (216.46.213.136):
In Reply to: Re: OT/saved some work posted by ken in texas on October 15, 2008 at 09:19:44:
I can top that. We put this whole new septic system in about 10 years ago because it wouldn't flush. With the whole thing new from where the pipe went in to the old tank on out,it still wouldn't. I rented a drain snake and ran it from the cleanout back up toward the house and pulled out the shredded remains of a small plastic baseball bat. One of the kids had dropped it down the vent pipe next to the house. Now THAT was an expensive repair. The vent is a lot higher now with some angles in it to keep THAT kind of thing from happening again. I happened to mention it to the neighbor when he said he was having trouble with his. It activated something in his memory. He had a small hole drilled in the PVC just before it went out of the basement and had a piece of copper tubing in it for some other "add on" drain. That copper had worked its way in and was stopping the paper and such. He pulled it out a little and solved the problem. Simple sometimes ain't it?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
