Posted by 135 Fan on October 14, 2008 at 21:28:45 from (24.70.95.205):
In Reply to: Mustang Skid Steer posted by NickA on October 14, 2008 at 16:33:47:
It's an older original Mustang for sure. What engine? Try to find out what type of drive it has and who makes the components. I'm just concerned that some parts might be hard to find. I agree that it needs a roll bar and almost more importantly, some kind of protection on the sides. I have heard that even the older wheel loaders that had the lift arms go beside the seat have crushed people. To run it the way it is, is extremely dangerous! If everything seems to work OK, the price isn't too bad but figure on at least $500 to have a decent roll cage and side screens built and put on. I think Mustangs were fairly well built but the original company went out of business. I think some of the former employee's brought them back and a few years later Gehl bought them out. Gehl and Mustang are almost identical except for maybe a different make of engine. It looks like it has been repainted in the picture and may not have originally been yellow. Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
