If you figured things correctly, along matched power to current demands - yes - you could adapt a 1000 RPM PTO to a 545 RPM generator and run the engine at a lower speed. But, that probably puts the tractor out of it's peak torque and efficiency curve.
It takes around 1 horse to make 500 watts of power. I've got a 15KW PTO rig I've hooked many times to my 32 horse IH tractor and it did fine. Also ran it on my little VAC Case. Can't say I ever used it at full capacity though. Ran my entire house on it, ran a 200 amp welder, etc. No problems.
A large PTO generator is never going to be efficient unless your're working the tractor in it's peak range. That's the curse of making your own power. Usally electric demands are intermittent so overall efficiency is low. A 3000 watt generator with a 5 horse gas engine will run a lot more efficiently at 3000 watts than a 30-50 horse diesel tractor hooked to a PTO generator - if only making 3000 watts.
The only way to get top efficiency when the demand is not steady is to use a battery bank and inverter. Run the bank until it gets low, then charge it up with a diesel generator sized properly to run at full efficiency to recharge the bank - and then shut down.
Another option - is to use a tractor hooked to a PTO DC generator and then through a large inverter. This way, you can run the tractor at any RPM and still get 60 cycle current.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
