In Reply to: Feeding Corn Stalks posted by jacksonduper on October 11, 2008 at 20:12:38:
We tried a little experiment with our left over sweet corn. It was still green, 8 feet high, and with a lot of cobs left. Mowed it down with the discbine with flail conditioner(beat most of the cobs off) side raked it up with old ground drive bar rake to clean up the cobs and round baled it for silage. Interesting to bale (hard core, 848 New Holland chain and bar baler)had to leave it spinning for a bit at end to pound stalks flat. Lots of plastic (8 layers) to wrap and heavy. Tipped over the wrapper when loading. 4'x5' bale is in the 2600 pound range at least. Let you know how the feeding goes this winter. I think I'll need the big loader for feeding them out, heavy stuff.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Weldin Basics, Part 3 - by Curtis von Fange. Oxy-acetylene Welding - Part One In our series on welding we have taken a brief look at AC and DC arc welding along with basic techniques and safety equipment required for safe usage. Since our premise is to cover welding types that might best be used on a farm environment we have kept our overview purposefully simple and general. The second type of welding that this observer finds quite useful in
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
