Buy 125' of 2-1/2" PVC pipe. Slip a cap on the end with some grease on the joint of the cap to pipe. Open the other well head to minimize pressure. Have the expandible rubber plug (mentioned) at hand.
Push the pipe , length by length down the casing with couplings at every connection glued as it is pushed down. When it hits bottom, Begin filling it with sackrete posthole mix concrete (small aggrigate). Use a funnel, and mix enough to fill the casing (roughly 8 cubic feet) (check this number!) Concrete weighs more than water, and when the fill pipe is full, begin pulling it out. The cap will come off, and concrete will begin displacing the water. Pull up 1/2 length of pipe at a time, and cut it off. Then refill the now partially empty fill pipe. You may need to cut shorter lengths off of the fill pipe to keep filling it at a rate that continually keeps the fill pipe near full. Water will be displaced up and out of the well as the concrete enters, that is a good thing. When the concrete gets near the top, Pull the remaining fill pipe, and put in the plug and expand it.
I believe that it is worth the bucks (Canadian)to try it. Putting concrete directly down the well washes the cement out of the aggrigate and makes porosity that will not work, this deposits real full strength mix to the place it will stay. Good luck, No guarantees, JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
