Posted by Ron in Nebr on October 04, 2008 at 20:21:40 from (66.252.113.175):
In Reply to: OT Pickup tire size posted by Joe Pro on October 04, 2008 at 20:12:05:
31x10.50x15's should fit without rubbing, might be iffy on tight turns if you plan to put 'em in front though. Wouldn't go much bigger.
In case you didn't know, to break down the tire size in this case, the "31" is the tire's diameter in inches, the "10.50" is roughly how wide it is, and of course the "15" is rim diameter. When you get into metric sizes like "P235/75/15" it gets a bit more complicated. There's websites you can find that'll break that down too(I'm too tired to type it all out)...
Keep in mind that increasing tire size(diameter) will throw off your speedometer readings, and also make it act like it has a higher rearend gear ratio(lower gear number numerically).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
