Posted by the tractor vet on October 04, 2008 at 19:54:54 from (99.167.208.219):
In Reply to: 504 doesn't like a load posted by missing in action on October 04, 2008 at 14:27:55:
Well here are a couple things to check , First change your plugs to autolites or motor crafts next clean up the ft pulley so ya can see the timing marks at between 20-22 degrees at RATED PTO SPEED . The timing for the earlie s/n is the 22 degrees and the 20 degrees is for the later engines and one other small thing CHANGE THE GAS YOU ARE USEING as the 504 falls under the 93 octane minimum req. for that engine . you vary well could have pistons swelling thus causeing the lack of power under load , Now correct me if i am wrong here but the 504 gasser had a selenoid fuel shut off on the carb and as long as the tractor starts then it is working and it goes into full fuel mod when the key is on . Now if by chance it still has the org. fuel shut down on it it may have a fuel adjusting screw in it and they should be set at 4-5 turns off the seat . Don't try and wean it back as lean is mean and can cause you more problems them ya want.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Ferguson TO-20 - by Staff. When the infamous "Handshake Agreement" between Henry Ford and Harry Ferguson fell by the wayside (that's a story in itself), Harry Ferguson quickly set up manufacturing plants for a United States version of his English TE-20. The TO-20 was relatively the same as the TE-20 except utilized some different casting materials and had a US-style electrical system. The TO-20 was a dead ringer for the Ford 9N and 2N models and they say that Ferguson did this on purpose when the Handshake Agreement wen
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
