Posted by RodInNS on October 02, 2008 at 18:17:15 from (216.118.158.123):
In Reply to: Re: Flipping Fordson posted by Steven f/AZ on October 02, 2008 at 15:24:10:
I think you would find that wide front tractors are less likely to tip. They aren't necessarly more stable... but consider this. With a narrow front, when the tractor starts to tip over, it's pivot point is at the ground about the inside front wheel. With a wide front, it's still siting on your tripod, but the pivot point is 2 feet in the air at the axle pivot pin. Both tractors, probably in many situations will sit near their balance point when they're about to tip... but the difference is that the narrow front while pivoting at the ground has nothign to restrain it from going over once it starts to go. A wide front is still going to hit it's axle stop, and as such will move it's center of gravity away from the direction it's tipping. It may still go over depending on the forces and speed involved, but it would be slightly less likely to tip. you're quite right in saying that there's been lots of wide fronts tip over though... there's been lots of both. Most of them as a result of a lack of common sense.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The River Tractor - by Charlie English Jr.. This is a 4010 John Deere that was used to farm on the Diamond Island which is in the Ohio River about 15 miles southwest of Evansville, Indiana. About ten years ago, this tractor was parked close to the bank as the river was washing the bank of the island away.
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
