Posted by mark on September 28, 2008 at 08:01:12 from (172.129.239.67):
In Reply to: Re: Pulling a subsoiler posted by fixerupper on September 27, 2008 at 19:29:06:
Jim,
I would imagine that most folks would also be wanting to cover some ground and get as much done in a day as possible. I was in no hurry and did all my work in low gear......no need in destroying the clutch or tearing something up.......if a truly big rock was encountered 2 feet deep.
Most hard pan is just below regular plowing depth....8" to 12" deep and 16" subsoiling should get it all. If I ran my single shank subsoiler at 16".......I could seemingly fly with it...hehe!
We have been in a drought this summer and the ground is so hard and bone dry. It was a great opportunity for me to hit that spot that generally is wet during a normal year. The mole ball makes a nice channel for the water to follow...at least that"s the theory.
And as for depth of penetration....yep, I measured how deep the shank was going...24"-25".
Still yet, I am surprised at how hard it is, to pull a narrow subsoiler through hard ground....it"s like dropping anchor!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Haying Before Tractors - by Owen Clark. Hi guys! At age 8 (1927, am now 79) I was learning how to drive a stacker team on the old homemade A-frame wooden stacker, on three of my uncles` dairy farms in Star Valley Wyoming (south of Jackson Hole, on the Wyoming-Idaho border). There was one steam tractor in the Valley, owned by an entrepeneur who used it to run his grain threshing machine, that he hauled from farm to farm for the fall harvest. We used teams of horses not only on the stacker, but on the buckrake to buck the dried
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
