1- farmall H 1944 with a duall loader. 1--John Deere B 1950 Just finished a complete engine rebuild.Awsome!!!! 1-- MTD Ranch King 2000 First and last of these I buy new. 1-- Wizard lawnmower ??? Best tractor on the place. SO says my wife. What CAN she know.
1-- Hand made steel wheeled lawn tractor. Used McCormick belt pulleys for rear wheels,Dray wheels for front(had to bush them as the axle was so much smaller than the inside diameter.Cut down the nose cone of an AC b to make the nose cone of this. Took part of a gas tank cover from a AC 14 for the hood. An AC b pan seat. Gambles rotiller motor (horizonal shaft) with a rubber belt transfering power to the rear which is from a fergason rider mower. Engine is set at a high idle and you can lift the front off the ground in all three gears. Have a weight to install on the front when the little ones play with it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
