I built my home in 1989.Final cost was about 60% of what a contractor had ask to build it.BUT,so much homework has to be done to save any money in the long run.You will have to get your plans of course and study them close for material estimates.A good building supplier will be able to figure your material using the plans also.But you need to be able to look at those plans and be able to understand them yourself.This will help you not only in the labor itself but,also in purchasing the material.That way you can shop for the best price and quality and not be tied to only one supplier.Or you might be able to buy from one supplier.But you do need to know exactly what you want and need.Also you will be dealing with,dirt men and concrete contractors for the footing,masons for the foundation and/or brick work,drywall hangers and finishers,electricans and plumbers,roofers and heating and air people.I was lucky as i had a friend who was a homebuilder that recommended some of these contractors to me and it worked out well.But if you have no one to help you it can be a pill to get good reputable contractors who do good work at a reasonable cost.All this takes time and careful research.Things have changed so much in the years since i built that i doubt that i would want to go through it again.I can remember working 10 hr.shifts on my regular job and coming in to work on the house at night.You have to take all this into consideration also.But if your determined and driven you can make it happen.And you can save some money.But you need to do everything that you can possibly do yourself.And you need to be around while the subs are working to be sure what you are getting from them.I can tell you from experience,its no walk in the park.Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
