Posted by jose bagge on September 14, 2008 at 04:54:32 from (12.161.55.2):
In Reply to: OT- Soldering Experts posted by MN Scott on September 13, 2008 at 19:26:13:
This brings back memories..my dad, when he was alive, owned a small company that built "spy guy" RF gear for the military. He had 3 or 4 assembly people ( mostly women) that soldered components to printed circuit boards at their home, and brought them in when completed ( he paid by the piece). See if there are any Printed Circuit Board manufacturers in your area...they probably have an assembly person that could do it on the side. There are more of these companies around than you might think- two miles from my house here in Va there's Colonial Circuits. Disassembly is best done with that solder wick that a prior poster mentioned- as he said, miniature gound strap that comes rolled in a can that looks like a flux can. The "expert" PC assemblers NEVER use flame or a Weller-type gun- they always used little pencil point soldering irons no more than 6" long, and also had little metal "soap trays" with wet sponges in them to clean the tip and keep temps down. heat is the enemy - it dstroys the board. The idea is to lay the wick over the solder, heat the wick with the iron and have it pull the solder off the backside of the component while you gently pull it off the board.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: The Old Gold National Antique Tractor Show - by Cindy Ladage. Over the fourth of July weekend, the Illinois State Fairgrounds in Springfield, Illinois, was the site of the Old Gold National Antique Tractor Show. Tractors of all makes and models were displayed and separted into categories by their age. Deere, Oliver and even a Wards and Keck Gonerman were part of the crowd. A sea of red International Harvester's seemed to be the the model with the biggest showing. The crowd was decent for the scorching July heat. The opening day started o
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
