Posted by Bobk478 on September 10, 2008 at 16:22:34 from (75.117.189.247):
Had to replace the radiator in my Ford 3600 (due to axle pin coming out, previous post) got the correct one (from company on this site) all look good except that the shroud does not attach. Old Radiator was 19 inch across top and 18 1/2 on bottom. New radiator is reversed. Needless to say the bottom being too wide is the issue. Not sure what to do, I don�t have any way to fabricate new shroud or brackets and I know you have to have the shroud or it wont cool right. The shroud feels and looks like plastic (sure it�s not but it something like that). Only thing I can come up right now is trying to heat it up and bend it a little (but not sure if you can do that)? any suggestions or words of wisdom would be greatly appreciated. Thanks
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A 1937 John Deere Unstuck - by Gary Hickman. Here is my story of how I got the pistons out of a 1937 JD B that the engine had been stuck for about 14 years: About 12 years ago my Dad gave me one of the tractors I ran as I was growing up on our farm in central Nebraska. The engine on this tractor, a 1937 John Deere "B", had been stuck for 2 years before he gave it to me. This last spring (1999) I hauled the tractor to our 2 acre lot in St. Libory Nebraska where it joined my antique machinery collection, at that time a 1929 Caterpillar T
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
