Posted by J.C.in AZ. on September 07, 2008 at 08:26:53 from (65.54.155.44):
In Reply to: O/T Welding Helmet posted by 37chief on September 06, 2008 at 23:04:40:
I'm only a Hobbiest Welder now but I enjoy my Lincoln Vista 2000 Helmet with the Star Spangeld Flag Graphics when I do weld. It performs very good and for some one who is used to useing a Hand Held Face Sheild it is very safe as I have a hand to guide or to hold onto stuff now.I do Flux Core Wire with my Lincoln 100 mostly but Stick Weld with my Forney 250 when needed. My most recent uncompleted project is a facsimle Model T Roadster with tiller sterring ,an 8HP Briggs with a Friction Clutch Drive under the Seat 14" Motor Cycle Wire Wheels and tires from two Honda Junkers etc. Lots of parts of these old Motor Cycles are being reinvented in my little project. It is for amusement only and an attention getter.Jc
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
