Posted by Gary from Va on September 01, 2008 at 17:57:49 from (71.63.92.59):
In Reply to: shop air lines posted by oj on September 01, 2008 at 17:50:16:
3/4" should be plenty big enough, 1" might be overkill. Not sure about Pex, might want to go with cpvc, or copper. Check the max. pressure ratings, they should be printed on the side of the tubing. I'd go with at least 200 psi rating. An air line that blows can send schrapnel flying everywhere. Another route is to use plastic air brake tubing like they use on big trucks. It will definately hold the pressure, you can get it in 3/4", it's pretty affordable and easy to get from any truck parts store, and it's flexible enough to be routed around obstacles without a lot of extra fittings.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Miracle Formula for a Stuck Engine - by Edited by Kim Pratt. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: I have a stuck 4 cylinder engine. Two pistons right at the top, other two down. From underneath everything looks good. Up top looks bad. Thanks in advance."
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
