Re: Electrical outlets for tractor shop

Posted by RodInNS on September 01, 2008 at 13:51:27 from (24.215.113.120):

In Reply to: Electrical outlets for tractor shop posted by Bookman on September 01, 2008 at 13:25:21:

I'm not sure what the NEC states on wire size, but I doubt that 10 ga is enough for a welder. You want 50 amp service for a welder. A couple outlets are good for the welder at each end or something along that line.
110 boxes should go every 10 feet or so I think. There would be a code on that too...
The compressor is something I'd put in an out of the way place and then hard plumb it in place with air lines. Service on that will be anywhere from 15-50+ amp depending on the compressor.

Rod

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Optional Video Title: Optional Video URL: Advanced Posting Options Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.   Advanced Posting Tools   Upload Photo  Select Gallery Photo  Attach Serial # List  Return to Post

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]