Posted by Randy-IA on September 01, 2008 at 08:00:19 from (207.177.83.172):
Hi All. I posted this over on the Oliver forum but thought I'd put it here too since this forum is much more active. I was hoping someone has done this before. It doesn't look like a hard job but it does look awkward to do by myself. I have a parts manual and it clearly shows a right and left side part number for the guard supports. The question is are the supports reversible ( keeping them on the side they came from ) to move the guard out further? Right now the guards are set as narrow as possible. I've got the wheels set for my plow which puts them almost outside of the guards. It doesn't look bad but I would like them to cover the wheels a little better. The trouble is that by only moving them the way the supports are attached to the guards now will only move them out about two or three inches. The guards attach to the inside of the supports. I want to move the guards to the outside of the support but that requires the support to be turned end for end. It looks like it (the support) will bolt to the axle in this position but I can't get good enough measurements to determine if the guard will bolt back onto the support that way. So that's all I need to know- if I turn the supports end for end will the guards bolt back up to them? Thanks! ...Randy
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that �quick look over� before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
