1) make sure he shows you a copy of his workers comp and liabilty insurance. Then call and make sure it is still inforce. VERY IMPORTANT !!!!!!! 2) decide if you are going to sell by the board foot or lump sum. If by the board foot you want to see the weight ticket from the mill for each load. 3) go over what is saw logs; plywood logs; and pulp wood. All grades pay differant amounts. 4) if selling by the foot tell him you want the pulp wood hauled off first. more than one cutter has been know to cut the high priced saw logs and then move out leaving the cheep pulp wood there. 5) decide who cleans up. this will affect the price. some will do a total clean up but you get nothing for the logs. some do not want to do any clean up at all. 6) the log loader or skidder does not leave your site till the final check is in your hand. 7) get several quotes. might even stop by a local yard and see what they will give you if you were to cut and haul. This will show you where you stand even if you do not intend on doing the cutting.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
