Posted by JML755 on August 22, 2008 at 09:35:09 from (66.184.63.110):
In Reply to: Copper Thieves posted by john in la on August 21, 2008 at 21:01:01:
If this happened more often, it might discourage SOME of the low-lifes:
-----------------
June 4,2008
VIENNA, Maine -- The owner of a machine shop where thieves stole $3,000 worth of scrap steel, iron and aluminum wasn't going to let it happen again. After Saturday night's theft, Joseph Lord loaded his shotgun and laid low, expecting the thieves to return. They came back on Tuesday, in broad daylight.
When Lord saw their 2008 F-250 pickup truck, he shot out its tires and windshield and blasted its radiator, Kennebec County Sheriff Randall Liberty said.
The startled thieves took off on foot, but investigators quickly tracked down the truck's operator, who will be charged with theft, Liberty said. Charges are pending against an accomplice, the sheriff said.
Liberty said he discourages the use of guns to protect property. In this case, Lord told investigators he wanted to disable the vehicle so the criminals couldn't escape.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
