Ok first off Don't be suprised if the rebuilt booster is not bad, as i went thru this a couple months ago . BUT FIRST OFF why did you replace it??? ,because you had no pedal . With old juice brakes on OLD trucks better then half the time when ya think the booster is bad all ya need to do is ADJUST the brakes as that takes some getting use to doing correctly . The master cylinder only moves somuch fluid along with the booster and when ya start having to PUMP the brakes to get pedal then the brakes are out of adjustment and with most larger trucks with juice brakes there are TWO adjusters to each wheel . ANd each one has to be adjusted correctly . One also has to keep in mind that there is NO dual braking system on these old trucks and everything MUST be wright the first time . The best way to bleed these old trucks is with a power bleeder because here again the master cylinder and booster can only move somuch fluid and normaly it is not enough with the routing of the lines . But here again it all comes back to brake adjustment. One other thing you MUST also look at is the brake hoses from the steel lines to the rear axle and to the ft. wheels . It is not uncommon for them to collapes inside and stop the flow of brake fluid to that wheel or axle . This will dive you nuts tryen to fine the problem . So best to change them all as i your life along with somebody else's if your brake job fails.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Hitches For Your Old Tractor - by Chris Pratt. For this article, we are going to make the irrational and unlikely assumption that you purchased an older tractor that is in tip top shape and needs no immediate repairs other than an oil change and a good bath. To the newcomer planning to restore the machine, this means you have everything you need for the moment (something to sit in the shop and just look at for awhile while you read the books). To the newcomer that wants to get out and use the machine for field work, you may have already hit a major roadblock. That is the dreaded "proprietary hitch". With the exception of the
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
