Posted by Wayne in MN on August 06, 2008 at 06:00:15 from (68.119.27.241):
In Reply to: Re: 6 volt to 12 posted by ba123 on August 06, 2008 at 05:55:18:
Did you set the point gap correctly? The rubbing block must be on the high point of the cam lobe (points open at their maximum)when setting the gap. Clean the points with some lacquer thinner or other non-residue liquid and then run a clean dollar bill through with the points closed.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - On the Road with Dave Gohl: Deere Departed Friend - by Dave Gohl. Have you ever had to part with a dear friend? It's not easy. If it's due to death, your feelings could be in disarray for days, months or even years. Even now after almost 4 years, I still miss my dad. I remember when I was a kid my dad sometimes would tuck my brother and I in at night and we would ask him questions about his childhood on the farm. To this day, it's some of the best stories I've ever heard. And now, I'm so glad that I asked those questions, and if I were a little smarter i
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
