Posted by gun guru on August 04, 2008 at 14:52:33 from (66.188.56.98):
In Reply to: Re: Rem 6.8mm SPC posted by ERP1233 on August 04, 2008 at 13:48:48:
I would look at the velocity of the round to see if the bullet will go through the deer. A good friend of mine has actually shot a deer with a 30-06 and the bullet went through the deer, My friend says a 30-30 bullet is better cause it doesnt go through. Try looking up the info on the NRA-ILA.org website. The NRA may have this info.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Ford 600 Series - by Staff. The Ford 600 Series tractors bean production in 1954, and continued until 1957. Quite similar to the Ford NAA (Golden Jubilee) in design, it used the same 132 cubic inch Red Tiger engine with 31 horsepower. Several different models were made in the 600 Series, and these numbers were used to denote whether they used a particular transmission, hydraulic system, or PTO. The result was five different model numbers: 620, 630, 640, 650 and 660. These break down as follows:
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
