Posted by dlplost on July 30, 2008 at 19:54:11 from (69.205.132.94):
In Reply to: 8n - adding a loader posted by bumpamartin on July 30, 2008 at 16:59:38:
A loader on an "N" works just fine, IF you do it properly. MUST have 16" tires on the front to keep tires from digging in on the turns. MUST have a counter weight on the back of the tractor. Requires enough weight on the back to make it steer with one hand when the bucket is empty. My backhoe weighs 1,500#. I allways have a minum of 500# on the back. Loaded rears will also help with traction. Sherman under drive will also help. I have the Sherman over/under...excelent addition to any "N"! You can tie down the 3 point and use the internal pump for hyd, BUT it is too slow and stops when you stop, you won't be happy with that. Works best with a front mounted pump driven by the crank.
Here's mine, has had a loader and backhoe on it since the early 80's, worked comercialy for 18 years of that, NEVER had any problem with the front end or the rest of the tractor due to either.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
