Posted by dlplost on July 24, 2008 at 10:05:57 from (69.205.132.94):
In Reply to: JD 1020 Dozer posted by Sparktrician on July 24, 2008 at 06:12:34:
Like jdemaris says probaly a 1010, But could it ba a 2010? 2010 is just a little bigger than the 1010, 47hp instead of 37hp.
Testing, Steering clutches and brakes aren't too bad to fix, but the tranny & drive clutches are killers to fix on these $$$. Make shure ALL gears both fwd and rev work and shift like they should, do some figure 8's with it BOTH directions. "worn out" under carrage can last for many years in occasional farm work, and over a period of years you can slowly rebuild the worst of it as time and money allow.
Here's a link to "HER" 2010 so you can compare. We paid $5,000 last year at auction, with 6way hyd dozer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
