The TSC paint is acceptable paint for about 75% of the projects a person could do. There are some though that deserve just a little better paint if you want to throw the money at it. I use a lot of the Valspar with the hardner and it comes out ok. Three years ago I painted an IH model 55 eleven shank chisel plow with really good Swift Red urethane that I bought at Car Quest. It has been parked in a fence row back on the property that I last used it and it looks like a show car after sitting ouside for three years. Very deep rich shiny paint job. I had to pay about $200 dollars for that gallon of paint with the catalyst that came with it. I actually bought it to paint the inside of a tractor cab and had enough left over for the chisel plow. Valspar would have cost me about $50 for the gallon of paint and hardner but it would not have turned out that nice. I think the paint was made by Western. Very good stuff. They have a color chart at Car quest for the off the shelf colors they offer. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
