Posted by Kevin (FL) on July 20, 2008 at 12:22:24 from (70.149.219.24):
Well, my son & I have started the job--small steps at a time--just got the truck jacked up on blocks and started the process. Like I said, small steps first--disconnected batteries, removing starter, began loosening drive shafts etc. My son noticed a chunk of aluminum broken out near the slave cylinder mount. This has me concerned since on the ZF, the bellhousing is one in the same with the transmission housing. I'm hoping I can patch this hole and drill crack stopper holes if I see any cracks. Lord knows we can't afford a new transmission housing and the labor involved in swapping the gears out etc. I had another question if anyone wants to weigh in:
Should I split the transfer case from the tranny before dropping the tranny or should I leave it connected? A buddy in our church (who does alot of mechanic work) is recommending I leave the two attached, but I heard other folks say to split them before lowering. As a reminder--this is a 2001 F350 SRW diesel 4x4 with the ZF 6 speed. We have a large (2000# cap.) tranny jack. Thanks in advance for any help. I work out of state and can only work the job for a few hours on Saturdays.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil�s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
