Posted by kyplowboy on July 19, 2008 at 23:10:38 from (63.146.226.90):
In Reply to: Re: O/T: Sudangrass posted by tjdub on July 19, 2008 at 22:15:36:
The only time I have ever herd of it cause'n a problem with Acid is after a frost, it is like wilted wild cherry leaves then.
If you have a real dry year it can have high levels of nitrates in it. Sounds like you could NOT have a problem with that this year.
I have not raised any the last seveal years. I have gone to pearl millet insted in my rotation from tobacco back to pasture/hay. Pearl millet does not from prussic acic so it can be grazed way up into the fall if it is wet or I just don't get round to work'n it up to plant grass/clover/wheat. It also is alot easier to get to cure if you don't have a conditioner. Some say it can't be done but I have cured sudan with 2 passes with a tedder, but it is a pain and still takes alot of time.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
