Posted by Lanse on July 16, 2008 at 18:42:49 from (64.12.117.74):
today i managed to get all the bearings in the "C", and it turns as it should thanks to agco shims. Tomorrow im hoping to put it back together. I have all the wireing cut off, so im just setting the battery in, then hooking up the starter. Then using the mag for the B on there. How do i shut it off?? This mag doesnt have anything for a grounding wire on it. So:
1. My manuel doesnt say how to install the new rear seal. Or the front (i guess you just slide the thing over the end of the crankshaft).
2. It doesnt say what to torque the oil pan bolts, or the rear seal bolts. Or the front seal.
3. how do i start it??? I know to spin the engine to get the oil pump going, but what else?? Diddnt someone say to run it for 15 minuites then change the oil???
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Listening to Your Tractor - by Curtis Von Fange. Years ago there was a TV show about a talking car. Unless you are from another planet, physically or otherwise, I don�t think our internal combustion buddies will talk and tell us their problems. But, on the other hand, there is a secret language that our mechanical companions readily do speak. It is an interesting form of communication that involves all the senses of the listener. In this series we are going to investigate and learn the basic rudimentary skills of understanding this lingo.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
