I dont know about that statistic but I"m a 40 year old guy that said for years I"LL NEVER GET MARRIED. Then I went and got married 7 months ago after knowing the lady for only two weeks. Since getting married I"ve gained nearly 15 lbs but I"ve taken my belt up a notch. That"s right, gained weight but decreased my waist size. If I shaved my moustache I"d easily pass for 10 or so years younger but I"ve always been told I looked younger than I am anyways. As a twentysomething I had several "exotic dancers" at my beck and call and back then thought I"d never say NO but now where others complain about not getting enough I"ve got more than I can handle and then some from one lady....and when I"ve got the energy left over and don"t have to say no it"s always GOOD. All that aside I can say that there were perks to being single and having a girlfriend, lots of toys, etc but when there was no one around it could get awful lonely at times. It"s so nice to know when I get home there"s someone there that loves me and cares about me. When I get ready for bed I know there"s someone there to snuggle up with. When I have a problem I know there"s someone that I can share it with....The list of perks goes on and on. The main thing I"ve found is that as long as a husband and wife can be open, honest, and communicate then married life is pretty good. If you start hiding your feelings, lying, and stop communicating then your looking at he11 on earth for sure. All I know right now is that I"m happier than I"ve ever been and looking forward to a long life together with my beautiful wife.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.