Posted by MarkB_MI on June 30, 2008 at 03:37:42 from (216.234.120.251):
In Reply to: Electrical Question posted by teddy52food on June 29, 2008 at 16:12:13:
Really your question is more mechanical than electrical. You really need to determine what torque is required to overcome the static friction of your bearings. Once you do that, it becomes a matter of sizing a motor with sufficient torque at zero rpm. Starting torque and operating horsepower (or "wattage", as you say) are pretty much independent of each other; starting torque depends a great deal on the particular type of motor.
Is this a real problem or a theoretical one? If it's theoretical, you can pick bearings that have almost zero static friction, in which case the starting torque would be small. At the other end of the scale, babitt bearing have very high static friction.
If you actually have this device built, you can put a torque wrench on the shaft and measure how much torque it takes to overtake the static friction in the bearings.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The David Brown Rose Badge - by Samuel Kennedy. In the 13th century civil war was raging in England. Two English noblemen were involved in a conflict which became known as the War of the Roses. The Duke of York had as his emblem a white rose and the Earl of Lancaster had a red rose. Today the white rose is the official emblem of the county of Yorkshire and the red rose has been adopted by the neighboring county of Lancashire.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
