Posted by cadet trooper on June 28, 2008 at 17:28:32 from (69.223.83.75):
In Reply to: Its over posted by Lanse on June 28, 2008 at 16:26:00:
Lanse, the three prong device you're asking about is called a swathing board normally used to keep a gap between your next swath for the hay rake they were usually made out of wood with a long wood dowell rod it looks like that one was home made if you cut a lot of grassy hay you would soon learn to hate this device because when the bar plugged you would have to back up and of course with the bar loaded up it became impossible to raise the bar so you would try to back up with it down and naturally you would hear a crack and the board was history. During a period wet hay silage was a rage and some companies designed a windrowing finger device to bolt on to the back of the bar what a monster? Ours lasted about two days and we only cut 5 acres with it last I saw it was on a scrappers truck ten years later. Good luck and have fun.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
