Posted by CBBC on June 26, 2008 at 12:21:22 from (70.67.127.206):
Hey B&D or any other electricions.
What size VFD would I need to run a 75HP 3 PH 600V Motor with? What would something like that cost????
I"m starting to think of a Soft Start / Stop due to the water hammer I"ve been experiencing on the irrigation pump. It just sheared a 8" sch 80 PVC pipe at the Victolic coupler. This was partly due to poor alignment, but something else is going on here. I have air bleeders at three points in the system so that shouldn"t be an issue.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The River Tractor - by Charlie English Jr.. This is a 4010 John Deere that was used to farm on the Diamond Island which is in the Ohio River about 15 miles southwest of Evansville, Indiana. About ten years ago, this tractor was parked close to the bank as the river was washing the bank of the island away.
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
