Posted by Mark - IN. on June 14, 2008 at 04:17:57 from (64.12.117.74):
In Reply to: Ohms a fuel gauge posted by Dan B on June 13, 2008 at 19:48:40:
Good morning Dan, I'd like to help you but am not sure. The only thing that comes to mind is going across the leads of the guage itself with an ohm meter, but I'm guessing that its voltage or current driven by the sending unit itself. Having never opened either, I would guess that the guage requires say either 6V or 12V to read full, but the sending unit has perhaps a variable resister (potentiometer) that when the tank is full allows either 6V or 12V to drive the needle full guage, and as the fuel level drops, increases resistanse thus decreasing voltage to the guage and dropping the meter. Unless someone has had past experience with the specific guage that you're dealing with, you might have to find it in a fuel sending unit book down at the auto parts place...and that'd be a good or best bet. I would not be surprised if a sending unit manufacturer's parts book wouldn't have a unit listed for an application...if you know what the fuel guage came out of, look it up.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Hitches For Your Old Tractor - by Chris Pratt. For this article, we are going to make the irrational and unlikely assumption that you purchased an older tractor that is in tip top shape and needs no immediate repairs other than an oil change and a good bath. To the newcomer planning to restore the machine, this means you have everything you need for the moment (something to sit in the shop and just look at for awhile while you read the books). To the newcomer that wants to get out and use the machine for field work, you may have already hit a major roadblock. That is the dreaded "proprietary hitch". With the exception of the
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
