Posted by mark on June 11, 2008 at 13:07:54 from (172.132.38.76):
In Reply to: plowing vs tiller posted by Scotty- mn on June 11, 2008 at 12:06:13:
Scotty,
I've owned a tiller for 25 +years. Like everything else, they have their pluses and minuses.
If you going to break ground...forget a tiller. Hard or sod ground will beat you and the tiller to death.
If working up previously worked ground, a tiller is great. HOWEVER, a tiller will break the soil so fine, that if you have a high clay content, after a hard rain, the soil runs together like concrete.
When you make a seedbed with a tiller, the soil looks wonderful....but that isn't always the best. It also chops up every earth worm...which may or may not mean anything to you, but they are natures soil builders. For incorporating compost...leaves grass clippings, etc., a tiller is super.
If are blessed with loamy soil...a tiller by itself might be the way to go. But again, only after the earth is broken.
To me, a tiller is a valuable extra implement to have, but I would never be without a plow and disc harrow.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
