Posted by Cummins 1955 on June 09, 2008 at 15:45:45 from (4.224.69.109):
In Reply to: raising large posts posted by StuBC on June 09, 2008 at 07:26:12:
I am going to take the easy way out here. We have a local truss contractor who has a boom truck and have found it to be the most reasonable SAFE way to do things. We moved round corn cribs and the roofs had to come off. Tried several different ways, and got them off, but it was dicy. Called boom truck out to put them back on out of desperation. Total charge $275 for 4 roofs(2002). We had that much in one gin pole that was not safe! We have had them out several times since for odd and ends and it is always very reasonable. If you are going to set trusses on top of them, I would set an afternoon appointment, and set the poles, work all evening with my buddys get all braced up and headers on and set trusses in the morning. Alot safer and much less headache. Maybe more than you know. LOL
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.