Posted by jdemaris on June 09, 2008 at 10:58:00 from (67.142.130.22):
In Reply to: raising large posts posted by StuBC on June 09, 2008 at 07:26:12:
I've put many 24 foot 6" X 6" poles in by hand, just me and my wife (and I'm not a big guy). Have your hole dug, put a vertical board in the hole - for the pole bottom to rub on as you walk it into the hole. Then - get on the end and walk it up. I've done 20 footers by myself - but that's my limit. With 24 footers, my I walk it up from the end and my wife walks it up from the middle.
Now, if your's are 8" diameter or bigger, the loader is a much better option. Just wrap a choker chain around the pole (self-tightening) a little above the center - and lift. With a 24 foot pole, you hook about 13 feet high. I have a 8 foot heavy steel pipe that I bolt to a backhoe bucket that makes a good extension for such work and gives extra height.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
