Posted by Bob85355 on June 09, 2008 at 09:45:35 from (4.240.33.77):
In Reply to: raising large posts posted by StuBC on June 09, 2008 at 07:26:12:
Well, I was a complete novice when I set a 20 foot pole some years back. After trying a couple of things that didn"t work, I figured out how to do it right. Built an A frame out of 2x4 leaving a small X at the top. Moved the pole into position and put a chain loose enough to slide around the bottom end and and staked it securely a couple feet behind the hole. Tied a rope to the top of the pole and crossed over the A frame. Put a piece of wood into the hole to keep the end of the pole from digging in. Hooked the rope to the back of a compact tractor and pulled. The effect was that the A frame caused the top of the pole to lift up and not simply to move forward. Slipped right into the hole.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
