Posted by ScottyHOMEy on June 03, 2008 at 20:43:17 from (71.241.220.120):
In Reply to: Re: wiring harness posted by RobMD on June 03, 2008 at 20:16:04:
Yep. He's got things listed for a LOT of tractors, so he's got to have a good bit tied up in field research.
Two things he does that I like. He labels every single wire (like the small wires up around the generator) and the terminals at each end of the wires in the harness with numbers that go to a crib sheet for what they are and where the ends go. And to top that, he uses the original colors for the insualtion and tracers on the wires in the harness itself, so that they actually match up to the colors on the IH diagrams in the manuals, so that you know where things go long after his temporary labels are gone.
I should add that I've heard good things about Brillman, too, but don't have any experience with them.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.