Posted by buickanddeere on June 03, 2008 at 17:07:13 from (209.240.119.30):
In Reply to: baler pto speed posted by RICK165 on June 03, 2008 at 15:08:28:
The flywheel is on there for a reason, to store energy. Energy is stored at a square of the rpm. The factory would have saved time and money making that flywheel smaller if they could have. They built it that size because it"s just large enough to store just enough energy at 540 rpm to reduce driveline wear to acceptable levels. If you are running the pto at 382rpm instead of 540 rpm.1485 engine rpm instead of 2100rpm for example. Then the pto drive line, over running clutch and gear box is stressed twice as much each plunger stroke. Then it would be at 540 rpm. Running the bailer at reduced speed saves nothing and adds wear if there is any significant volume of hay passing through it. The plunger also has half the inertia behind it to cut and compress the bale. Bearing loads on the crank, rod,pin and rollers is increased.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Perfect Restoration - by Chris Pratt. Often, in quiet moments, I have wandered back in my thouhts to the many tractors I have seen over the years and wondered which one inspired me the most. Sure, we have a fond attachment to one brand and model or another, sometimes it was remembering that first time we got to climb up in the drivers seat and command that roaring beast, or maybe because when you see that special model, you can't help but see Dad on it, he's gone, but everytime you see a tractor like his, it's a like part of him i
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
